What is in the checklist
- The two Great Britain rules that ended most general-lighting fluorescent lamps being placed on the market
- What those rules do not do: they do not force you to switch off fittings you already have
- Three replacement routes, in plain language
- When a new, warranted luminaire is the clearer path
- Polaris fittings that often replace fluorescent battens, panels and high bays
- A survey list and official sources
The official dates, in plain English
This is often described as a fluorescent tube ban. In law, two sets of Great Britain rules stopped most general-lighting fluorescent lamps being placed on the market. They apply in England, Scotland and Wales. We have not verified the position in Northern Ireland, which can differ, and we do not give NI dates.
From 1 September 2023, the ecodesign rules for lighting products raised the threshold efficacy for 2-foot, 4-foot and 5-foot T8 fluorescent lamps to 120 lm/W. That figure is in Schedule 3, Table 2 of the Ecodesign for Energy-Related Products and Energy Information (Lighting Products) Regulations 2021 (SI 2021/1095). Typical fluorescent T8 lamps do not meet that threshold, so those sizes could no longer be placed on the market as compliant light sources from that date. Source: legislation.gov.uk, SI 2021/1095, Schedule 3.
From 1 February 2024, the RoHS mercury exemptions for many general-lighting fluorescent lamps expired. That includes non-integrated compact fluorescent lamps, T5, T8, T12 and long-life linear fluorescent lamps, as listed in Schedule A2 to the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012, as amended (including by SI 2023/658). After the expiry date, those lamps must not be placed on the GB market if they contain mercury above the RoHS limit. Sources: the current Schedule A2 table; the GOV.UK record of the Secretary of State determinations; and the explanatory note to SI 2023/658, which states that the revoked exemptions expire on 1 February 2024.
Some special categories have later expiry dates in the same RoHS table, including certain special-purpose lamps and emergency lamps (24 February 2027 for the emergency-lamp entry). Those later dates are not a reason to leave a general-lighting workplace on fluorescent tubes.
What you can still use
The rules above are about placing lamps on the market in Great Britain. They do not require you to switch off fluorescent fittings that are already installed and safe. You can keep using the lamps you already have. Replacements for general lighting are, however, becoming harder to obtain because new lamps can no longer be placed on the market under the expired exemptions and the ecodesign thresholds. We have not made a general claim about the sale of leftover stock, because that depends on when a lamp was first placed on the market.
Three replacement routes
There are three common ways to move from a fluorescent batten, trunking run or recessed modular fitting to LED. They are not equivalent.
- LED replacement tubes, sometimes called retrofit tubes, that are intended to work in the existing fitting, often with the existing control gear still in circuit. Compatibility varies, and the original fitting was not designed or warranted as an LED luminaire.
- A ballast-bypass or rewired conversion, where the existing body is kept and the control gear is removed or altered so that LED lamps are fed more directly. This can be a competent electrical alteration, but the result is still a converted fitting, not a new luminaire with a current product warranty.
- A new LED luminaire, such as a PS-BATTEN, a PS-PANEL or PS-PANEL+, a PS-UFO-MAX high bay, a PS-CORROSION washdown batten, or a PS-BULKHEAD. The complete fitting is designed, tested and supplied as an LED product, and every Polaris product carries a 5-year warranty on the fitting. That warranty does not apply to emergency packs or batteries.
A rewired fluorescent body can look tidy and still leave you with an old housing, uncertain photometry and no manufacturer warranty for the conversion. For a workplace that needs a known light level, a known emergency duration, or a clean hygiene rating, a new fitting is usually the clearer path. We have not stated that every conversion is unsafe, and we have not invented failure rates.
Polaris fittings that often replace fluorescent
- PS-BATTEN is a 1,500 mm LED batten with a built-in microwave sensor, about 7,800 lumens at 60 W (130 to 140 lm/W), IP65. A 3-hour emergency version is available. The 5-year warranty is on the fitting, not on an emergency pack or battery.
- PS-PANEL is a backlit panel for 600 x 600 and 1,200 x 600 exposed ceiling grids, with selectable power and colour temperature, UGR below 19, and a 5-year warranty.
- PS-PANEL+ is a 1,200 x 300 panel at up to 160 lm/W, IP44, with an optional remote 3-hour emergency pack. Again, the 5-year warranty is on the fitting.
- PS-UFO-MAX is the switchable 100, 150 or 200 W high bay at 190 lm/W for halls that used to use fluorescent high bays. Lumens at each wattage (19,000, 28,500 and 38,000) are calculated from 190 lm/W. A PIR and daylight sensor is included as standard.
- PS-CORROSION is an IP69K tubular batten for washdown areas, with a Tridonic driver and a 5-year warranty.
- PS-BULKHEAD is an 18 W IP65 polycarbonate bulkhead, including emergency versions, with a 5-year warranty on the fitting (emergency batteries excluded).
For a wider upgrade method, use our warehouse LED lighting upgrade checklist. For factory and warehouse context, see industrial lighting and warehouse lighting.
Frequently asked questions
Is there a fluorescent tube ban in the UK?
In Great Britain, two official rules ended most general-lighting fluorescent lamps being placed on the market: the ecodesign efficacy threshold for 2-foot, 4-foot and 5-foot T8 lamps from 1 September 2023 (SI 2021/1095, Schedule 3), and the expiry of RoHS mercury exemptions for T5, T8, T12 and non-integrated compact fluorescent lamps on 1 February 2024 (Schedule A2 to the RoHS Regulations 2012, as amended). The rules do not require you to switch off fittings already installed.
Can I still use the fluorescent tubes already in my building?
Yes. The official rules are about placing lamps on the market, not about banning the use of lamps you already have. Plan the replacement, because new general-lighting fluorescent lamps can no longer be placed on the GB market under those provisions.
Is a retrofit LED tube the same as a new LED fitting?
No. A retrofit tube uses the existing body. A ballast-bypass conversion alters that body. Neither is the same as a new LED luminaire that has been designed, tested and warranted as a complete product. Polaris warrants its fittings for 5 years. That warranty does not cover emergency packs or batteries.
Do emergency fluorescent fittings have a later date?
The RoHS table still lists a later expiry for the emergency-lamp mercury exemption, on 24 February 2027. That is not a reason to leave general lighting on fluorescent tubes. Emergency lighting should be designed as a complete system. See our warehouse emergency lighting page if you are reviewing emergency packs.
How do I get the fluorescent to LED checklist?
Enter your name, organisation and email in the form on this page. You can download the free PDF straight away. You can also ask for a free survey if you are planning a project.

